K-edge K13-440 Manuale Utente Scaricare il pdf

GO Big Mount Installation Instructions

(K13-440, 450, 460)

Description:

The K-Edge GO BIG ¼”-20 Mount series is designed for installation of a camera with a ¼”-20 universal mount to virtually any

surface.

Compatibility:

The K13-440 GO BIG ¼”-20 Pro Handlebar series is designed to attach any camera with the standard universal mount in front of

bicycle handlebars, out of the way of your hands and your vision.

The K13-450 GO BIG ¼”-20 Adapter mount is designed to attach any camera with the standard universal mount directly to our

original GO BIG Mounts (K13-400, 410, 420, 430) allowing mounting to virtually any surface*.

The K13-460 GO BIG ¼”-20 Saddle Rail is designed to attach any camera with the standard universal mount OR GoPro / GARMIN

VIRB (with GARMIN supplied adapter) mounting system to rails underneath a bicycle saddle.

* Use K13-450 adapter in combination with K13-400 (the K13-400 is also equipped on K13-420, 430, and 460) to mount on flat

surfaces (i.e. walls, skis, snowboards, cars, etc.) using either industrial double sided adhesive or screws/bolts (hardware not

included). In certain situations, caution is strongly advised to ensure proper mounting and safety.

Warnings:

These instructions are generalized to accommodate a wide ranges of setups for a bike. If your setup does not match what is being

described, take extra care in the process of your setup and contact K-Edge Support if you have any questions.

Improper installation of any K-Edge product or use outside of its design intentions could lead not only to damaging the bike but could

also cause personal injury to the rider.

1 2 3 4 5 6

GO Big Mount Installation Instructions (K13-440, 450, 460) Description: The K-Edge GO BIG ¼”-20 Mount series is designed for installation of a

Parts Included:  K13-440  1x GO BIG ¼”-20 Pro Handlebar mount  1x ¼”-20 Thumbscrew w/ head Keyed to 5mm Hex  1x Silicone O-Ring (Orange) Dash

Installation Steps: Note: Prior to installation please ensure that the camera mounting bolt is installed correctly. K13-440 (Pictured Below): NOTE

K13-450 (Pictured Below): NOTE REGARDING ALIGNMENT BOLT: Some cameras have alignment hole(s) to prevent rotation and maintain alignment. This ‘alig

K13-460 (Pictured Below): 1. Follow the instructions for the K13-450 on the previous page to install camera. Note: If the saddle bolts on the K13-

Troubleshooting:  Camera mounting bolt is tight but camera itself is still loose (i.e. rotates/pitches easily). o Check that the camera mounting b

Modelli collegati K13-450 | K13-460 |

Nessun commento